Viking VGDO271, Сервисный журнал, Страница: 22 / 52

DISASSEMBLY PROCEDURES
Lower Oven Door Latch / Door Plunger
Light Switch Assembly
1. Turn off power to unit.
2. Remove top oven door, see “Oven Door” procedure.
3. Remove screws securing center trim between oven
doors.
4. Remove screws securing latch assembly to chassis.
5. Remove latch assembly from chassis.
6. Disconnect and label wire terminals.
7. Reverse procedure to reinstall door latch assembly.
Oven Light Bulb / Oven Light Socket
1. Turn off power to unit.
2. Open oven door to gain access to oven light.
3. Unscrew (counterclockwise) glass knurled dome.
4. Using a glove, unscrew (counterclockwise) oven
light bulb.
NOTE: Proceed with the following steps for oven light
socket removal.
5. Remove screws securing unit to the wall.
6. Remove oven from cutout opening and disconnect
gas supply.
7. Disconnect or unplug the power cord leading from
unit to fuse box or junction box depending on unit.
8. Remove screws securing outer wrapper cover and
remove.
9. Carefully displace fiberglass insulation away from
rear of light socket.
10. Push inner assembly of light socket toward rear of
range, or twist out, depending on style of base.
11. Disconnect wires from light socket.
12. Reverse procedure to reinstall light socket.
Reposition insulation around lamp socket. Do not
over tighten.
NOTE: Reposition fiberglass insulation around oven
light socket to eliminate possibility of heat
related problems.
Oven Liner Removal
NOTE:
Unit should be run through at least one clean
cycle to set insulation.
1. Turn off and disconnect both electric and gas
supplies to oven.
2. Remove oven door and oven racks.
3. Remove oven bottom and temperature sensor. Pull
capillary tube through side of oven.
4. Remove oven light cover and bulb.
5. Remove bake burner, ignitor, broil burner, and broil
ignitor.
6. Remove chip cover.
7. Remove cabinet back.
8. Remove screws securing oven liner at the rear.
Maneuver oven liner from frame by pulling
outward.
9. Reverse procedure to reassemble.
When reinstalling new liner, use flat sheet metal strips 4
X 28 inches to prevent insulation from “bunching up”
as new liner is installed.
NOTE: When removing oven liner be certain not to
dislodge the broil air duct on the right side of
cabinet. If air duct is dislodged, broiler burner
will not function as it will disrupt the flow of air
to the broiler, resulting in poor air-gas mixture.
22