Viking VCSB48, Сервисный журнал, Страница: 29 / 33

29
Damaged module housing Replace Ice Maker
Deformed shut-off arm Replace shut-off arm
Little or no alumilastic on thermostat Apply alumilastic to thermostat
Housing to mold screws not seated Tighten 2 screws (20-26 in.lb) (22.8-29.6 cm.kg)
Heater not staked in mold Replace Ice Maker
Incorrect heater temperature Replace Ice Maker
Broken shut-off lever or Replace Ice Maker
mislocated shut-off switch
3:00 Ejector Position
Contaminated Replace Ice Maker
Jammed cubes Un-jam cubes
Notice size and density of cubes
Refrigerator or ice maker not level level refrigerator or ice maker
No power to ice maker Determine discontinuity be tracing power
Excessive water fill volume Adjust module screw, lower water pressure or replace
water valve.
Cubes falling back into mold during ejection Replace fill cup. Check fill tube assembly.
4:00 Ejection Position
Contamination Replace Ice Maker
Thermostat out of calibration Replace Ice Maker
Open heater circuit, motor should oscillate Replace Ice Maker
Little or no alumilastic on thermostat apply alumilastic to thermostat
Heater not staked in mold Replace Ice Maker
Broken locking tabs on vertical cam Replace Ice Maker
6:00 Ejection Position
Contamination Replace Ice Maker
Insufficient water to ice maker, Refer to “Hollow Ice Cubes”
small or hollow cubes