Viking VCSB48, Сервисный журнал, Страница: 25 / 33

25
Ice Maker
Ejector Blades or Stripper
1. Remove module and support assembly.
2. Install ejector blades, realigning “D” coupling
with module cam.
Accessing Control Box
1. Remove motor and contact assembly from
control box be removing 3 screws.
2. Remove shut-off arm.
3. Pull
free.
Switches will jam if turned counterclockwise and
gears will be destroyed if turned clockwise. Advance
ice maker into cycle be using a jumper to bridge H to
R. Ice maker will not run if motor is defective. Shut-
off arm must be in on position.
There are several slotted shafts on motor assembly
board. Do not insert screwdriver and attempt to turn
shafts. Slots permit assembly only.
There are non-repairable and non-replaceable
components in module. When diagnosing or
repairing ice maker, do not remove module unless
replacing module.
Water Fill Valve
Turning water level adjustment screw will move
contact in relationship with contact ring segment.
This causes contact to vary time water valve is
energized. Contact ring is tapered at end of fill time.
•
Turning screw clockwise decreases fill time.
•
Turning screw counterclockwise increases fill
time.
•
½ turn equals 20 cc or 1.2 seconds.
•
Full turn equals 40 cc or 2.4 seconds.