Viking RDSOE306SS, Руководство по обслуживанию

Страница: 4 / 60

© 2012 Viking Preferred Service
44
General Information
Warnings
Read and follow all instructions before using this
appliance to prevent the potential risk of fire, electric
shock, personal injury, or damage to the appliance
as a result of improper usage of the appliance. Use
appliance only for its intended purpose as described
in this manual.
To ensure proper and safe operation: appliance
must be properly installed and grounded by a
qualified technician. DO NOT attempt to adjust,
repair, service, or replace any part of your appliance
unless it is specifically recommended in this manual.
All other servicing should be referred to a qualified
servicer.
Electrical Requirements
Check your national and local codes regarding
this unit.
• Oven requires a separate, grounded 4-wire,
240V (AC), 30 amp service (single oven) or 50
amp service (double oven) with its own circuit
breaker.
• Wire sizes and connections must conform
with the rating of the appliance and to the
requirements of the National Electrical Code,
ANSI/NFPA 70 – latest edition, or Canadian
Electrical Code, CSA C22.1-1982 and C22.2 No.
01982 – latest edition, and all local codes and
ordinances.
• Oven must be connected to the proper electrical
voltage and frequency as specified on the
model/serial rating plate (located under right
side of control panel).
• Oven must be connected to grounded metal
permanent wiring system. Check with a qualified
electrician to make sure the oven is properly
grounded.
• DO NOT ground to a gas pipe.
• DO NOT use an extension cord with this
appliance, because this may result in electrical
shock or other personal injury.
• This unit is equipped with a No. 10 ground wire
in the conduit.
• The electrical conduit must be kept to the
top left for a flush installation. NEVER cut
the conduit.
• Connect the flexible armored cable directly to
4-wire, 240V household service. If codes permit
and separate grounding wiring is used, we
recommend that a qualified electrician determine
the grounding path and that the wire gauge is in
accordance with local codes.
• Junction boxes installed on rear wall
directly behind oven must be recessed
and located at the upper left-hand corner
of the cabinet.
• A UL-Listed conduit connector must be
provided at the junction box.
• DO NOT install a fuse in the neutral or
grounding circuit. We recommend a time
delayed fuse or circuit breaker. Connect directly
to the fused disconnect (or circuit breaker
box) through flexible armored, or non-metallic
sheathed, copper cable (with grounding wire).
Cleaning Safety
• Turn off all controls and wait for appliance parts
to cool before touching or cleaning them.
• Clean appliance with caution. Use care to avoid
steam burns if a wet sponge or cloth is used
to wipe spills on a hot surface. Some cleaners
can produce noxious fumes if applied to a hot
surface.
Self-Clean Oven
• Clean only parts listed in this guide. DO NOT
clean door gasket. The door gasket is essential
for a good seal. Care should be taken not to
rub, damage, or move the gasket. DO NOT
use oven cleaners of any kind in or around any
part of the self-clean oven.
• Before self-cleaning the oven, remove broiler
pan, racks, and other utensils and wipe up
excessive spill-overs to prevent excessive
smoke or flaming.
• This range features a cooling fan, which
operates automatically during a clean cycle.
If the fan does not turn on, cancel the clean
operation and contact an authorized servicer.
General Information
To avoid risk of property damage, personal
injury or death, follow information in this manual
exactly to prevent a fire or explosion.