To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
WARNING
!
Oven Light Bulb Removal
DO NOT touch bulb with bare hands. Clean off any
signs of oil from the bulb and handle with a soft cloth.
1. Open oven door and unsnap glass light cover
using a screwdriver in the access groove.
2. Firmly grasp light bulb and pull out.
3. Replace with halogen bulb using volt and
wattage requirements listed on glass cover.
4. Replace the light cover by snapping glass cover
onto metal box.
1
2
3
4
Top Light Housing Removal
1. Access control components (see Control
Components Accessed).
2. Remove glass light cover and bulb.
3. Disconnect connector for top light and housing
ground wire.
4. Use a putty knife to depress tab in front of light
housing and tilt front of housing down to remove
housing from cavity.
5. Reverse procedure for installation.
Door Lock Assembly Removal
1. Access control components (see Control
Components Accessed).
2. Remove screws and door lock assembly from
range.
3. Mark and disconnect connectors from door lock
assembly.
4. Remove door lock assembly and door latch
insulation from range.
5. Reverse procedure for installation.
Disassembly
40
©2012 Viking Preferred Service
Содержание RDSCE230-5B
Страница 45: ...Wiring Diagrams 2012 Viking Preferred Service 45...
Страница 46: ...Wiring Diagrams 46 2012 Viking Preferred Service...