To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
WARNING
!
Motor Capacitor Removal
1. Access Control Board (see Access Control
Board Assembly).
2. Mark and disconnect wires from capacitor.
3. Remove nut, lockwasher, and capacitor from
lower mounting plate.
4. Reverse procedure for installation.
Door Assembly Removal
1. Open door completely. Place pins supplied
with unit in pin holes.
Important:
For personal safety, only use
pins supplied with unit. Pins can be ordered if
needed #005116-000.
2. Remove screws and hinge trim from range.
3. Gently close door until pins stop door.
4. Lift door up and out.
Note:
If the door needs to be adjusted, loosen hinge
trim screws. Adjust the screws located between
the door and kick plate using a
5
/
32
" hex head
Allen wrench. Tighten hinge trim screws after
adjustment is made.
5. Reverse procedure for installation.
Door Gasket Removal
1. Open door and insert a narrow tool or small,
flat-blade screwdriver into the center of each
clip and pry upward.
2. Remove the door gasket from two holes in
the bottom of the door liner.
3. Reverse procedure for installation.
Door Assembly
Adjustment Screw
Disassembly
34
©2012 Viking Preferred Service
Содержание RDSCE230-5B
Страница 45: ...Wiring Diagrams 2012 Viking Preferred Service 45...
Страница 46: ...Wiring Diagrams 46 2012 Viking Preferred Service...