14
When set to “Enabled” the Operation Commands (
0 to
1) to Un-Latch or Latch the relay are enabled. These can be
entered on a Inbound call after the access code is dialed (if programmed).
When set to “Disabled” the Operation Commands (
0 to
1) to Un-Latch or Latch the relay are disabled. Disabling the
Latch commands can be useful in applications where you want to eliminate the possibility of inadvertently entering a
latch command leaving a gate open/closed, etc.
Factory Setting:
Enabled
18. Relay Latch Commands
The relay activation tone is a buzzing sound that is heard from the speaker when the door strike relay is activated.
After the called party enters the correct relay activation command, the called party will hear 2 short confirmation beeps
and the entry phone will output a buzzing sound (relay activation tone) while the door strike relay is activated. The tone
(buzz) length will match the relay activation time up to a maximum of 5 seconds. The tone (buzz) can be programmed
to three different volume settings 1 = Low, 2 = Medium, 3 = High or it can be disabled.
Factory Setting:
3
17. Relay Buzz Volume
The one or two digit code stored in the Relay Activation Command is the touch tone command that the person being
called must enter on their phone in order to momentarily activate the relay to control a doorstrike, mag-lock, gate
controller, or other device. The code can contain the characters 0 - 9, # or
. The code cannot match a relay latching
command (
1,
0). The code must be entered while the remote phone is communicating with the Speaker phone.
Factory Setting:
15. Relay Activation Command
The value stored in the Relay Activation Time is the amount of time the relay will be energized after a correct momentary
touch tone command is entered. This number can range from 0.5 - 99 seconds. This also affects timing in Doorbell
Mode.
Factory Setting:
5 seconds
16. Relay Activation Time
14. Relay Mode
Door Strike Mode.
When programmed for Door Strike Mode the relay will momentarily activate for the preprogrammed
relay activation time after detecting the correct relay activation command (one or two digit touch tone) from the called
party.
Outbound Call Mode.
When programmed for Outbound Call Mode the relay will activate continuously for the duration
of any outbound call from the Emergency/Entry phone. This mode is useful for activating strobe lights for Emergency
VoIP phones.
Inbound/Outbound Call Mode.
When programmed for Inbound/Outbound Call Mode the relay will activate
continuously for the duration of any inbound or outbound call to or from the Emergency/Entry phone. This mode is
useful for turning on IR flood lights, VoIP phones with cameras, etc.
Doorbell Mode.
When programmed for Doorbell Mode the relay will momentarily activate the relay for the
preprogrammed relay activation time on any outbound call from the Emergency/Entry phone. This mode is useful for
activating a door chime, etc. When activating door chimes, a 0.5 - 1 second relay activation time is recommended.
Ring Mode.
When programmed for Ring Mode the relay will continuously activate when the
PB-3-IP
’s extension is
called. This mode is useful for activating a Viking model
SL-2
strobe light, etc.
Ring Flash Mode.
When programmed for Ring Flash Mode the relay will momentarily turn on and off in a 400ms on/off
cadence when the
PB-3-IP
’s extension is called. This mode is useful for activating a Viking
LPL-1
Remote Visual
Indicator, etc.
Alarm Mode:
When programmed in Alarm Mode the relay will activate continuously while the unit is powered and
registered to the SIP server. In the event the unit loses power and/or SIP registration the relay will turn off, which can
be used to signal an alarm device.
Note:
Alarm mode cannot be used with external relay control (
RC-4A
).
Factory Setting:
Outbound Call Mode
