13
13. Relay Internal / External
With the relay set to “Internal” the
PB-3-IP
Phone will activate its on board relay for door strike / gate control. The Relay
should be set to “External” for higher security installations when using a Viking remote model
RC-4A
relay controller
to activate the door strike / gate controller (see DOD 582).
Factory Setting:
Internal
The
PB-3-IP
Emergency Announcement can be uploaded with any user edited WAV file. See “WAV File Guidelines”
below. Alternatively the announcement can be recorded via a telephone call (See section 12 below).
WAV File Guidelines:
Note:
Applications such as Sound Forge, Audacity, and Windows Sound Recorder can be used to create the WAV files.
11. Audio File (optional)
1.
The WAV file should be 8 or 16 bit PCM mono or stereo.
2.
Sampling rates of 8k,16k or 32kHz are acceptable.
3.
The WAV file may be stereo or multi-channel, but only the Left Channel will be loaded.
4.
When saved, wave files will be converted to 8KHz, mono, 16 bit, PCM.
5.
The internal flash memory can hold up to 28 seconds of recorded audio.
12. Recording Emergency Announcement from a Phone
Step 1.
Call into the
PB-3-IP
with a Touch Tone phone and access programming by entering the security code (845464 is the factory default).
Step 2.
Enter
4, wait for the tone and then begin recording (28 seconds of record time is available).
Step 3.
Enter # to stop the recording. Playback (for reviewing) is automatic.
Step 4.
Enter
5 to review the announcement again.
Step 5.
If you choose to not use a voice announcement, enter
3 to clear the recording.
Example:
“Emergency, Hudson High School classroom 243 needs assistance. Press the asterisk (
) key on your telephone to hear this
announcement again. Press “#” key for two-way communications. ”
