Viking MT 830, Руководство пользователя

Страница: 26 / 144

EN - 20
Operating the Tractor
MOWER DECK REMOVAL & INSTALLATION
Removing the Mower Deck
Note:
Perform mower removal on a hard, level surface
such as a concrete floor.
1. Park the tractor, disengage the PTO lever, turn off the
engine, remove the key, disconnect the spark plug
wire(s), and engage the parking brake.
2. Place mower in the lowest cutting position using the
mower height adjustment lever (A, Figure 4).
3. Remove the mower belt from the engine pulley
(D, Figure 4) by flexing the engine belt guide rear-
ward slightly, and pulling the belt off the pulley.
4. Remove the hair pin clip from the clutch rod
(C, Figure 4).
5. Remove the clutch rod (C, Figure 4) from the bottom
of the PTO lever (B). Reinstall the hair pin clip
removed in the previous step.
6. Remove the hair pin clip from the long hitch rod
(A, Figure 5).
7. Remove the hitch rod (A, Figure 5) from the mower.
8. Turn wheels straight ahead. Pull back on spring-
loaded lever (B, Figure 6) and lift mower hitch off of
the tractor bracket (A).
9. Turn wheels fully left, and slide mower deck out from
under the right side of the tractor. Reinstall the hitch
rod and hair pin clip (A, Figure 5) in the mower.
Engage parking brake, disengage PTO, stop engine,
disconnect spark plug wire(s), and remove key before
attempting to install or remove the mower.
WARNING
The muffler and surrounding areas may be hot.
CAUTION
Figure 4. Mower Deck - Right Side
A. Height Adj. Lever C. Clutch Rod
B. Bottom of PTO Lever D. Engine Pulley
Figure 5. Mower Deck - Right Side (38” Deck shown)
A. Long Hitch Rod & Hair Pin Clip C. Clutch Rod
B. Mower Drive Belt D. Rear Hitch Brackets
Figure 6. Mower Deck - Right Side
A. Tractor Hitch Brackets B. Spring-Loaded Lever
B
C
D
A
B
C
D
A