Viking MB 6 RH, Инструкция пользователя

Страница: 47 / 544

0478 111 9917 F - EN 13
D
E
E
N
F
R
N
L
IT
E
S
P
T
N
O
S
V
D
A
P
L
S
L
H
U
H
R
C
S
Removing / installing
the upper cover
Removing the covering
hood:
• MB 6 RV:
Unscrew tank cap.
Loosen
29= bolt and remove bolt to-
gether with washer.
Lift
D= covering hood upwards
and remove.
Installing the covering
hood:
Guide the four
35= locking pins into the
holes in the side panels
and push downwards in
direction of arrow. Then
using gentle pressure,
press down on the
D= covering hood. Tighten
29= bolt together with washer
(
4 - 6 Nm ).
• MB 6 RV:
Screw on tank cap.
16
Cleaning the appli-
ance
Clean the high grass mower
thoroughly after use. Looking
after your appliance carefully
will protect it against damage
and extend its service life.
Clean the underside of the
high grass mower with water
and a brush. Release any
accumulated cutting deposits
in the housing beforehand
using a stick.
Never sprinkle engine
components, seals, bearing
points or electrical parts with
water. This would result in
expensive repairs.
Clean the mowing blade.
Do not use aggressive
cleaning agents. These
cleaners can damage plastics
and metals, impairing safe
operation of your VIKING
mower.
If you are unable to remove
the dirt with water, using a
brush or a cloth, VIKING re-
commends the use of a spe-
cial cleaner (e.g. STIHL
special cleaner).
Please note:
When performing cleaning or
maintenance work, empty the
tank, fold the handlebar
forwards and tilt the high
grass mower as shown; the
spark plug must point
upwards.
15
Maintenance interval:
Each time the appliance
is used
CAUTION
Risk of injury!
Before tipping up the
mower, place it on firm,
level and flat ground and
select the lowest cutting
level (level 1).
Appliance may tip over du-
ring operations in this posi-
tion (see Figure 15). Always
stand to the side of the ap-
pliance. Never work in front
of or behind the mower.
Removing the side panels:
Loosen
31= screws and remove the
screws and washers
(two screws at the sides,
two at the rear).
Loosen the
34= screw and remove.
32= Push the tab in direction
of arrow and remove the
side panels.
Installing the side panels:
Assemble the side
panels on the mower,
guide the cables through
the apertures in the side
panels as shown and
ensure correct positioning
of
32= tab.
Tighten
34= screws to 1 - 2 Nm .
Fasten the side panels
with the
31= screws with washers to
the mower and tighten
(twice on the side, twice
on the rear) (
4 - 6 Nm ).