5
Installation and Mounting
VIKING
©
1
2
3
4
5
6
7
8
9
0
#
*
9
0
#
*
8
7
6
5
4
3
2
1
Optional VE-5x10
Surface Mount Box
(not included), see DOD# 424
10.0"
9.5"
4.50"
2.596"
5.00"
8.65"
0.425"
0.952"
Front View
9.12"
2.5"
4.5"
Zinc-Plated Steel
Rough-In Box
(included)
Side View
(8) #6-32 x 1/2" Stainless
Steel, 5/64" T-10 Torx
Security Screws (included)
14 Gauge Marine Grade 316
Stainless Steel Faceplate
10.14"
3.69"
5.22"
- OR -
Earth
Ground
Earth Ground the
Green/Yellow wire
using the
provided wire nut
Paper Directory
Directory
Lens
A. Mounting
The
K-1270-IP
is designed to be installed in a sheltered location, and is not meant to be used outdoors. For outdoor
applications use the
K-1270-IP-EWP
. The
K-1270-IP
can either be installed as a flush mount unit using the included
rough in box, or as a surface mount unit using an optional
VE-5x10
or
VE-5x10-SS
. The rough in box uses the inner
set of four holes on the face plate while the
VE-5x10
uses the outside set of holes. A set of dummy screws and nuts are
provided to fill the unused mounting holes.
Note:
Write down the MAC Address (found on the RJ-45 jack) as this may
be needed to identify the unit after installation.
B. Changing the Directory
To install a directory, remove the four screws that
mount the directory lens to the front of the
K-1270-IP
using the included Allen wrench. Insert a paper
directory behind the lens and secure the two back onto
the front panel being careful to align the names with
the front panel graphics.
Note:
To print directory forms for the
K-1270-IP
, go to
www.vikingelectronics.com and enter “930” in the DOD
field at the top of the page for a direct link to the PDF.
