19
35. Mute Current / Next Alarm
A network failure alarm will be indicated by providing 3 beeps every 30 seconds. A network failure indicates the unit is
not registered to the SIP server or there is a communication failure with the gateway. The three beeps can be muted
by clicking on “Mute Current / Next Alarm”. The Status LED will continue to flash to assist troubleshooting. The alarm
beeps can also be permanently disabled. See Permanent Alarm Mute.
36. Permanent Alarm Mute
Selecting “Alarm Tones Disabled” will mute all alarm tones indefinitely. To re-enable alarm tones select “Alarm Tones
Enabled”.
Factory Setting:
Alarm Tones Enabled
37. IP Firmware
If new
K-1270-IP
firmware is available, after opening the programming software a pop window will come up asking you
if you would like to update firmware. An alternative method of updating can be done by clicking the IP firmware “Update
IP” button. You can then browse to the folder that contains the PIP file for updating the unit’s IP firmware. This method
is typically only used when Viking Technical Support has sent you updated IP firmware.
38. Unit Firmware
If new
K-1270-IP
firmware is available, after opening the programming software a pop window will come up asking you
if you would like to update firmware. An alternative method of updating can be done by clicking the Unit firmware
“Update Unit” button. You can then browse to the folder that contains the HEX file for updating the unit’s firmware. This
method is typically only used when Viking Technical Support has sent you updated firmware.
39. Import/Export
The Import/Export feature is useful for backing up all the
K-1270-IP’s
programming or for importing programming when
installing multiple units with a majority of the same programming.
