After the rough-in box or
VE-5x5
is securely mounted, caulking between the box and rough opening is completed (if re-
quired), and wires are connected, remove paper liner from faceplate gasket. While firmly holding the LED light pipe in
the faceplate, carefully slide the faceplate gasket over the back of the light pipe and press gasket to the back of the
faceplate. Push the 1-1/4" 6-32 screws through faceplate holes and small holes in gasket, the faceplate gasket should
retain the screws. Position circuit board mounting plate over screws. Align screws with double gang box bosses and
tighten face plate until gasket is fully collapsed and the push button is protruding through the clearance hole in the face
plate. Included 1/4" thick gasket will provide an adequate seal for most siding surfaces; however for rough surfaces (ie:
brick, stucco, etc.) additional caulking may be required.
D. Mounting the Faceplate
Circuit Board
Mounting Plate
(included)
1/4" Thick Foam
Faceplate Gasket
(included)
Facplate
(included)
(4) 6-32 x 1.25" Long 5/64"
Hexdrive Flathead Screws
(included)
"Old Work" Double Gang
Rough-In Box (Allied Molded
9312 box shown, not included)
WARNING: Do NOT use a wet
location box.
(4) Optional Dry Wall
Screws (not included)
Optional VE-5x5 Surface Mount Box with
black satin powder paint finish, not included
(DOD# 424). Optional VE-LIGHT kit can be
used to illuminate the faceplate when used
with a VE-5x5 (DOD# 428).
WARNING: Do NOT use a wet location box.
2.25”
5.14”
5.22”
3.25”
3.63”
3.63”
|
OR
|
(2) Junction Box to Double Gang
Adapter Plates and (4) 5/64 Hex
Drive Flat Head Screws
(included with the E-60-IP)
3.65"
wide
min.
2.84"
tall min.
*2.25"
deep
min.
** LED
Light Pipe
(included)
Rear View of VE-5x5
Surface Mount Box
(not included)
(4) 0.38” diameter holes
for gooseneck mounting
(4) 0.2 x 0.43 slots
for double gang box
(2) 0.2 x 0.43 slots
for single gang box
(1) .74"
diameter
3.0” 3.3”
3.0”
Model E-60-SS-IP
shown in an optional
VE-5x5 Surface
Mount Box and
VE-LIGHT mounted
to a VE-GNP
Gooseneck Pedestal
Other pedestal
options available,
see DOD# 424
The optional VE-5x5 Surface Mount Box
(above) is designed to be surface mounted
to a single gang box, double gang box or
VE-GNP Gooseneck Pedestal (shown right).
For more information on the VE-5x5 and
VE-GNP, see DOD# 424.
* CAUTION:
Excessive wire length and/or using a rough-in box with inadequate depth can apply force to the circuit board causing
physical damage.
** IMPORTANT:
Push LED light pipe into faceplate hole, then place faceplate upside down on a clean flat surface and push down
on back side of plate until light pipe is fully seated and straight.
WARNING:
Inserting the light pipe more than one time can cause
a loose fit.
6
