Viking Designer DMOR200SS, Руководство по обслуживанию

Страница: 7 / 37

7
DMOR200SS
Electrical Requirements
The oven is equipped with a 3-prong grounding plug. DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE
GROUNDING PIN FROM THE PLUG.
The power supply cord and plug must be connected to a separate 20 Volt AC, 60 Hz, 5 Amp. or more dedicated line,
using a grounded receptacle. The receptacle should be located inside the cabinet directly above the Microwave Oven/Hood
system mounting location.
OVEN DIAGRAM
3-Pronged Plug
Grounded
Receptacle Box
Grounding Pin
3-Pronged Receptacle
Pr
oduct Contr
ols
Oven door with see-through 1
window
Door hinges
2
Waveguide cover 3
DO NOT REMOVE.
Turntable motor shaft 4
Oven light - on during operation 5
and when the door is open.
Safety door latches - door must
6
be securely closed for the oven
to operate.
Cook and time display
7
LIGHT Hi/Lo pad - controls 8
interior light
Press the LIGHT Hi/Lo pad once
for Hi. Press again for Lo. Press a
third time to turn the light off.
FAN Hi/Lo pad - controls fan
9
Press the FAN Hi/Lo pad once
for Hi. Press again for Lo. Press a
third time to turn the fan off.
Control panel 10
One touch DOOR OPEN 11
Push to open door
Louver 12
Nameplate 13
Louver screws - remove 14
screws to replace
charcoal filter.
Removable turntable
15
- rotates clockwise or
counterclockwise
Only remove for cleaning
Removable turntable
16
support
1. Carefully place the
turntable support in
the motor shaft in the
center of the oven
floor.
2. Place the turntable on
the turntable support
securely.
Heat deflector 17
1 6
2
3 4 5
7
8
9
10
12
15
16
6
11
13 17
14 14
(Front of Microwave)
(Rear of Microwave)
18
19
Light cover 18
Grease filters 19
Bottom of Unit