6
E
aBoUt UnPackinG anD eXamininG YoUr
Drawermicro
oven
1. Remove all packing materials from inside
the DrawerMicro
Oven. DO NOT RE-
MOVE THE WAVEGUIDE COVER, which
is located on the top of the DrawerMicro
Oven.
2. Remove the feature sticker, if there is
one. Check the drawer for any damage,
such as misaligned or bent drawer, dam-
aged drawer seals and sealing surfaces,
broken or loose drawer guides and dents
inside the cavity or on the front side of the
drawer. If there is any damage, do not op-
erate the DrawerMicro
Oven and contact
your dealer or a VIKING AUTHORIZED
SERVICER.
eLectricaL GroUnDinG
inStrUctionS
This appliance must be grounded. In the event of an electrical short circuit,
grounding reduces risk of electric shock by providing an escape wire for
the electric current. This oven is equipped with a cord having a grounding
wire with a grounding plug. It must be plugged into a wall receptacle that is
properly installed and grounded in accordance with the National Electrical
Code and local codes and ordinances.
WarninG
- Improper use of the grounding plug can result in a risk of
electric shock.
electrical requirements
The oven is equipped with a 3-prong grounding plug.
DO NOT UNDER ANY CIRCUMSTANCES CUT OR
REMOVE THE GROUNDING PIN FROM THE PLUG.
DO NOT USE AN Ex TENSION CORD. If the power
supply cord is too short, have a qualified electrician
or serviceperson install an outlet near the appliance.
The Power Supply Cord and plug must be connected to a separate 120 Volt
AC, 60 Hz, 15 Amp, or more branch circuit, single grounded receptacle. The
receptacle should be located inside the cabinet directly above the Microwave
Oven mounting location.
information YoU neeD to knoW
Waveguide
Cover
Sealing
Surface
Oven
Cavity
Sealing
Surface