10
Touch Tone Programming
A. Accessing the Touch Tone Programming Mode
1. Using the Security Code to Enter Programming
Step 1.
From a touch tone phone call the
E-10/20/30/32-IP
phone you would like to program.
Step 2.
When the
E-10/20/30/32-IP
phone answers, enter the 6-digit security code (factory set to
845464
, see section
B
). A
double beep should then be heard indicating you have entered the programming mode.
Step 3.
You can now touch tone program the
Quick Programming Features
listed on page 11.
2. Manually Resetting the Security Code to Enter Programming
Step 1.
Power down the
E-10/20/30/32-IP
phone by disconnecting the RJ45 plug.
Step 2.
Press and hold the CALL button, then reconnect the RJ45.
Step 3.
Continue to hold the button until you hear 2 beeps, (approximately 6 seconds). Then release the button. The “Call
Connected” LED will remain off for the first 3 seconds, flash slowly for 3 seconds then fast flash (after 2 beeps) indi-
cating when to release button.
Step 4.
The security code is now reset to
845464
(factory default).
Step 5.
You can now enter touch tone programming by following the steps in section
1. Using the Security Code
, above.
Step 1.
Access programming as shown in
Programming
section
A
.
Step 2.
Enter
123456 #19
.
Step 3.
Hang-up.
B. Security Code (#19)
The security code allows the user/installer to program the
E-10/20/30/32-IP
phone. The factory set security code is
845464 (V-I-K-I-N-G). It is recommended that the factory set security code be changed.
Note:
The security code must
be 6 digits and cannot include a
Q
or a
#
.
Example:
To store 123456 as the security code:
C. Manually Resetting All Network Parameters to Factory Default
Step 1.
Power down the
E-10/20/30/32-IP
phone by disconnecting the RJ45 plug.
Step 2.
Press and hold the CALL button, then reconnect the RJ45.
Step 3.
Continue to hold the button until you hear 2 beeps, (approximately 6 seconds). Continue to hold the button until you
hear 4 more beeps, approximately 6 seconds later, then release the button. The “Call” LED will remain off for the first 3
seconds, flash slowly for 3 seconds (2 beeps), fast flash for 6 seconds (4 beeps), then light steady indicating when to
release button.
Step 4.
The unit should continue to output double beeps and slowly flash the LED indicating all Network Parameters are now
reset to factory default.
Step 5.
You must now power cycle the unit by momentarily disconnecting the RJ45.
Step 6.
You will be required to re-enter your initial network settings prior to any touch tone programming, see section B on
page 9.
