IMPORTANT
ROLLER ADJUSTMENTS TO ACCOMMODATE OUT OF SQUARE OPENINGS
1.
Loosen the roller height adjustment screw to allow for movement. [See Fig.1]
2.
Fig. 1A displays the 2 different positions.
3.
If your walls are plumb and level, follow the configuration in Fig. 2.
4.
In the case that your wall is off on the top, the rollers should be adjusted as shown in Fig. 3.
5.
In the case that your wall is off on the bottom, the rollers should be adjusted as shown in Fig. 4.
FIG. 1A
IMPORTANT
NOTE: These adjustments are approximate. You may need to adjust the roller height adjustment
screw to meet your needs.
NOTE: There is an adjustment on the roller to accommodate walls that are not 100% plumb.
The bottom screw on the face of the roller adjusts the height of the ball bearing inside. Loosen
this screw, adjust to desired closed door position and tighten in place. You may need to remove
door unit from install to modify height.
ROLLER (3)
ROLLER HEIGHT
ADJUSTMENT SCREW
FIG. 1
Lowest position
Normal position
21
MODEL VG06045
Highest position
