Vigitron MaxiiNet Vi30018, Руководство по эксплуатации

Страница: 97 / 122

Page | 97
Switch Name:
The Switch can be named by entering the text into this box. This name
will be sent out in the alert messages and can be used to identify the
specific unit where the alert originated. If the box is blank, the IP address
of the Switch will be sent for identification.
UDP Alerts:
To enable or disable this function, click the down arrow located under
“UDP Alerts” and select the appropriate option.
To broadcast the alert messages, check the box next to “Broadcast”.
To send alerts to a specific IP address, type the address into the “UDP
Client IP Address” text boxes. The same Subnet mask that is used when
setting up the IP address of the Switch will also be used in the UDP
messaging. Be sure to un-check the Broadcast check box prior to
inputting the IP Address.
Finally input the port to be used and click the “Update” button.
TCP Alerts:
To enable or disable this function, click the down arrow located under
“TCP Alerts” and select the appropriate option.
Type the IP Address of the server into the “TCP Server IP Address” text
boxes. The same Subnet mask that is used when setting up the IP
address of the Switch, will also be used in the TCP messaging.
Next input the port to be used and click the “Update” button.
Update:
To apply any changes that are made to the messaging setup the “Update”
button must be clicked on the bottom of the page.