14
Altering/Accessing the Time Program for Domestic Hot Water Production
The time program consists of four heating cycles. In the factory default setting
cycle 1 is set for every day of the week from 05:30 to 22:00 hrs, which means
that during this time period domestic hot water production takes place.
The automatic mode is also preselected, which means that domestic hot water
heating takes place simultaneously to the time program for space heating, with
starting point 30 min. prior to the set time program for space heating.
The following options are available to you to set the heating cycles to your liking:
H
By selecting the corresponding heating cycle, domestic hot water heating can be
activated and deactivated up to four times a day.
H
You can select the same heating cycle or individual cycles for each day of the
week.
If you require domestic hot water production on a one-time basis and outside of the
programmed heating cycles, e.g. after 22:00 hrs, press
(see section “Setting the
Party Mode”) twice with approx. 2 to 3 seconds in between.
Setting the same heating cycles for each day of the week
Automatic?
Time Prog. DHW
Time
1---7
1. Open flip-down cover of remote
control.
2.
for time program “Time
Prog. DHW“, wait until
display shown on the left
appears.
3.
for “Individual?”.
4.
to confirm.
5.
for “DHW Heating Cycle
1”.
6.
for “DHW Heating Cycle 1
On”.
7.
/
for entering the start of
Cycle 1.
8.
to confirm;
display switches to “DHW
Heating Cycle 1 Off”.
9.
/
for entering the end of
Cycle 1.
10.
to confirm;
display switches to “DHW
Heating Cycle 1 On”.
11. For setting starting and ending
times for Cycles 2 to 4 proceed as
described in steps 5 to 10.
12. Close flip-down cover of remote
control.
If you would like to terminate the
heating cycle settings prematurely, press
again
If you would like to skip a heating
cycle, press .
Once the last setting is confirmed
with
the display will show the
current time.
51
67
50
5
