GB
General notice (liability): the details of this technical documents serve for description. Consents regarding the availability of certain features or
regarding a certain purpose always require a special written agreement.
Page 10 GB
Right reserved to make technical changes!
GB
3.10 Mechanical works on the door or the hatch
Important!
For door and view hatch panels, mechanical work in the
marked area (e.g. drilling, sawing) is prohibited. This
applies both for the exterior and for the interior.
Electrical components have been foamed in here.
Danger to life may result from damaging the integrated
electrical wires!
3.11 Coldroom without flooring panels
The wall panels are placed in plastic U-channels which are
screwed onto the floor of the room in which the coldroom is
assembled. These are constructed such that they form a seal
with the floor of the building. During assembly the wall
panels are either riveted to the U channels or screwed onto
them.
Caution!
To avoid damage to the floor of the building, ensure prior to
drilling in the floor that the cement coating does not
contain an damp proof layer which might be damaged. In
addition, the drill holes must be placed such that they are
not under the cam locks of the panels.
The door panel without flooring
is supplied with transport
securing plates and without door frame heating. Remove
transport securing plates for assembly of the door.
3.12 Closing the operational openings of the cam locks in the
wall and ceiling panels
Fill the openings with the insulating foam fillers supplied (D)
and seal with plastic plugs (E).
12 mm
a
aaa
aa
D
E
