Viega 8350.31, Инструкция по эксплуатации, Страница: 46 / 48

Remove the cable of the programming contact.
Place a protective cap onto the contact.
3.4 Faults, faults and remedy
Error Cause Remedy
WC does not flush Power supply failure actuate manual flush
Cistern is not yet completely full Wait until the cistern is sufficiently
full
No water in cistern, corner valve is
closed
Open corner valve
Control defect Replace control
Plug connection power pack /
control not made
Create plug connection
Ä
„Con‐
necting the control“ on page 26
Plug connection drive unit / control
not made
Create plug connection Ä „Con‐
necting the control“ on page 26
WC flush runs through Dirty seal in filling valve Check seal, replace if necessary
Dirty seal in drain valve Check seal, replace if necessary
Plug sequence drive unit / control
incorrect
Check plug connection, observe
coloured marking Ä „Connecting
the control“ on page 26
manual actuation is not working The mechanism is not connected
to the bow
Hang the mechanism in the bow
Handling
WC flush actuation 46 from 48