67009600-EN - Edition 2015 - Rev. 1.0
29
VX2300 Digital System - “2 Wire” Audio/Video Door Entry System
VX2300 Digital System - Installation handbook
PUSH BUTTONS, LEDS AND CONTROLS (FIG. 1)
Intercommunicating call button.
For an intercommunicating call, when the videomonitor is in stand-by, press as many times as the extension or ad-
dress value to call.
Door open button.
During a call, operation of this button will activate the “door open” relay (NO1, NC1, COM1). LED 4 will illuminate if
terminal 6 has been connected to a door contact.
LED 1
LED for programming purposes.
LED 2
LED relating to the operation of the answer/switch off/camera recall/simplex button.
LED 3
LED relating to the operation of privacy button.
LED 4
LED relating to the operation of door open button(powered from the connection terminal “6” of Art. 5980)
Loudspeaker volume control.
Call tone volume control.
Brightness control.
Colour intensity control.
PROGRAMMING
The videomonitor setup consists of the following settings:
• Number of Rings;
• Privacy duration;
• Melody selection;
• Unit address (1..255, switches 1 to 8 of SW1);
• Bus Termination (open or close, switch SEL1 position “Term.OFF” or “Term.ON”);
• Use with distribution box Art.317 (JP1 Closed if the videophone is connected to one Art.317)
• Intercommunication mode (between apartments or within apartment switch 1 of SW3);
• Extension address (1..4, switches 2,3 of SW3);
• Slave mode (switch 4 of SW3);
• Privacy duration (switches 1,2 and 3 of SW2)
The programming of the number of rings, privacy duration and melody are carried out through the videomonitor push buttons ,
all other settings are carried out on the two dip-switch banks (SW1 and SW3) on the rear side of the video monitor (the back cover
need to be removed).
Except the number of rings programming, it is necessary to remove temporary the power supply after making any other
programming changes.
NUMBER OF RINGS, MELODY SELECTION AND PRIVACY DURATION
First of all make a camera recall to switch on the unit then proceed with the programming operation.To alter the number of rings
and select the melody, the videomonitor must be in program mode. This is achieved by operating the two following buttons at the
same time (left button of the volume control and the right button of the colour intensity control) see Fig.1A 8 small buttons towards
the bottom of the face plate (far left button and far right button together). When the programming mode is entered LED 1 (Fig. 1)
starts flashing. This will automatically reset after 20 seconds of idle time.
NUMBER OF RINGS
• When in the programming mode press and hold the
button, LED 1 will stop flashing and LED 3 (Fig. 1) will start to flash
showing the number of rings (each flash = 1 ring i.e. 6 flashes = 6 rings).
• Once the value of rings has been reached release the
button.
• Wait approx 10 seconds for LED 1 to stop flashing to signal that the new value is stored and program mode has exited.
PRIVACY DURATION
• When in the programming mode press and hold the
button, LED 1 will stop flashing and LED 3 (Fig. 1) will start to flash
showing the number of times the button is pressed (each flash = 15 minutes i.e. 8 flashes = 2 hours ).
• Once the duration required has been reached release the
button.
• Wait approx 10 seconds for LED 1 to stop flashing to signal that the new value is stored and program mode has exited.
Art. SL5488N
Slim hands free videomonitor
