Videx VX2300, Руководство по установке

Страница: 60 / 100

67009600-EN - Edition 2015 - Rev. 1.0
60
VX2300 Digital System - “2 Wire” Audio/Video Door Entry System
VX2300 Digital System - Installation handbook
REMOVE THE BACK COVER
Fig. 1 Fig. 2
1. To install the videophone, it is necessary to remove the back cover. Apply pressure to the two openings indicated by the grey
arrows (
Fig. 2
) using a flat screwdriver.
2. Insert the screwdriver blade in the opening (
Fig. 1
) with an angle of 45 degree and press lightly (simply press, do not force the
opening with the screwdriver blade) to unfasten the bottom hook and, at the same time, lightly pull the upper part in the di-
rection of the white arrows of
Fig. 2
.
N.B.repeat the same operation with both openings.
FLUSH MOUNTING INSTRUCTIONS
135cm
Fig. 3 Fig. 4
1
1
2
2
Fig. 5 Fig. 6
1. First of all remove the back cover as described above;
2. Protect the holes to fix the videophone to the flush mounting box then embed the flush mounting box in line with the wall in a
horizontal position at 135cm height from the floor as shown in Fig. 3 ;
3. As shown in Fig. 3 , fix the back cover of the videophone to the flush mounting box keeping the same orientation shown in the
figure and taking care to feed the connection cables through the specific circular opening;
4. Connect the wires using a flat screw driver then setup the dip-switches as per provided connection diagram or instruction sheet
and fix the front part of the videophone to the back cover as shown in Fig. 5 : hook first the bottom side then rotate the front part
and hook the upper side;
In order to avoid malfunctions, please do not over tighten the screws.
5. The video intercom is installed (
Fig. 6
), power up the system and check that it works correctly.
Kristallo Series
7" flush and surface videomonitor wall mounting instructions