ENUK - V1.4 - 25/01/17
46
4000 Series GSM Audio Intercom - Technical Manual
4000 Series GSM Audio Intercom with Proximity
USER COMMAND TABLES
The following user command table shows the user commands that can be carried out during a call. Successful commands are
signalled by two beeps from the telephone, errors are signalled by four beeps.
FUNCTION
1st KEY TO PRESS
2nd KEY TO PRESS
Latch the relay (unlatch by pressing 3)
1
0
Release the door or gate
3
n/a
Activate auxiliary output AO1*
7
6
n/a
Activate auxiliary output AO2*
8
5
n/a
Adjust door speech volume (GSM speaker)
4
0 - 9 (0 = lowest, 9 = highest)
Adjust phone speech volume (GSM mic)
7
0 - 9 (0 = lowest, 9 = highest)
*7 -
Activating auxiliary output AO1 in this way is only possible when
A1M
mode has been set to mode 01 (also see notes on page
35, ‘set auxiliary output AO1 mode’) and will operate for the programmed AO1 time. If the AO1 output time has been set to latch
simply press 6 on the phone to unlatch the output again.
*8 -
Auxiliary output AO2 will activate for the programmed AO2 time. If the AO2 output time has been set to latch simply press 5 on
the phone to unlatch the output again.
The next user command table shows the SMS text messages that can be sent to the GSM intercom while in standby (the examples
shown in the table use the default 4 digit master code 1111).
FUNCTION
MESSAGE TO SEND
Check the signal strength
1111SIG?
Check the available balance*
9
1111BAL?
Check the software version
1111VER?
Release the door/gate
1111RLY? (? optional, send if confirmation is required)
Latch the relay
1111RLA? (? optional, send if confirmation is required)
Unlatch the relay
1111RUL? (? optional, send if confirmation is required)
Activate auxiliary output AO1
1111A1O? (? optional, send if confirmation is required)
Latch auxiliary output AO1
1111A1L? (? optional, send if confirmation is required)
Unlatch auxiliary output AO1
1111A1U? (? optional, send if confirmation is required)
Activate auxiliary output AO2
1111A2O? (? optional, send if confirmation is required)
Latch auxiliary output AO2
1111A2L? (? optional, send if confirmation is required)
Unlatch auxiliary output AO2
1111A2U? (? optional, send if confirmation is required)
Check Time band setting
1111TBA?
Check Intercom Time and Date
1111CLK?
Check Input Status
1111CHK?
Find a Dial to Open (dial to open) number
1111FDT”yyyyyyyyyyy”? (where yyyyyyyyyyy = telephone number, minimum of 4
digits, also refer to pages 42 and 43)
Find a Fob or Card location
1111FDF”nnnnn”? (where nnnnn = 5 digit user code printed on fob/card, also refer
to page 43)
*9 -
The balance can only be checked if the correct balance check string has been stored (also see
SDL
notes on page 37).
User Commands
