Videotec WASPT, Инструкция по эксплуатации

Страница: 23 / 134

Instruc
tion manual - English - EN
21 MNVCWASPT_2045_EN
8 Maintenance
CAUTION! Device installation and
maintaining must be performed by
specialist technical staff only.
8.1 Extraordinary maintenance
(to be done only under particular
circumstances)
8.1.1 Fuses replacement
Maintenance must be performed with the
power supply disconnected and the circuit-
breaker open.
Check the causes that caused the fuse
breakage. In the event the problem occurs
again, contact the technical assistance
service.
8.1.1.1 Replacing the fuse of the pump
board
If necessary, the board's fuse can be replaced (6.5.1
Installing the fuse, page 9). The new fuse must
comply with the directions given in the table.
FUSE REPLACEMENT
Model Number Alternative 1 Alternative 2
T 4A H 250V 5x20 BUSSMANN
S505-4-R OMEGA
GT520240
Tab. 3
As an alternative, use an approved fuse featuring the
same characteristics.
8.1.1.2 Replacing the fuse on the pump inlet
The operation is performed only for a pump
with a 5m or 11m delivery head.
Once the box is open identify the fuse position.
Fig. 47
If necessary, the pump input fuse can be replaced.
The new fuse must comply with the directions given
in the table.
FUSE REPLACEMENT
Model Number Alternative 1 Alternative 2
Pump with 5m (16ft) delivery
T 2A L 250V 5x20 BUSSMANN
S506-2-R OMEGA
ST522220
Pump with 11m (36ft) delivery
T 4A L 250V 5x20 BUSSMANN
S506-4-R OMEGA
ST522240
Tab. 4
As an alternative, use an approved fuse featuring the
same characteristics.
9 Information on disposal
and recycling
The European Directive 2012/19/EU on Waste
Electrical and Electronic Equipment (WEEE) mandates
that these devices should not be disposed of in the
normal flow of municipal solid waste, but they should
be collected separately in order to optimize the
recovery stream and recycling of the materials that
they contain and to reduce the impact on human
health and the environment due to the presence of
potentially hazardous substances.
The symbol of the crossed out bin is marked
on all products to remember this.
The waste may be delivered to appropriate collection
centers, or may be delivered free of charge to the
distributor where you purchased the equipment at
the time of purchase of a new equivalent or without
obligation to a new purchase for equipment with size
smaller than 25cm (9.8in).
For more information on proper disposal of these
devices, you can contact the responsible public
service.