Videotec MAXIMUS MPX, Инструкция по эксплуатации

Страница: 5 / 116

Instruc
tion manual - English - EN
3 MNVXMPXTH264_1825_EN
1 Addendum
1.1 Device configuration
CONFIGURATION OF ENCODER H.264
Address 1
Protocol NETWORK
Serial line termination (1) ON
Tab. 1 The position of all the other dip switches is irrelevant.
For further information refer to the relative chapter in
the manual of the product (Serial line terminations,
Protocol configuration).
1.2 Software interface
Only for product IP versions.
1.2.1 Minimum system requirements
The supplied controlling software supports up to 16
channels. The software requires Windows XP Service
Pack 3 or higher and a PC with an Xeon processor at
2.3GHz or higher.
1.2.2 Configuration procedure through
software
Once the pan & tilt has been preset and configured,
start configuring the IP parameters.
The IP address of the various units should be
configured using a PC.
Set the IP address of the PC: 192.168.10.1 (or
192.168.10.2, etc.).
Connect the unit to the LAN network, provide power
supply and start the browser (minimum Microsoft
Internet Explorer® 6.0).
To set the IP address of the various units,
power them, taking care to connect them
one at a time to the LAN (switch). Configure
the unit and insert the settings for at
least the IP address and host name. Once
configured, connect the Ethernet cable and
go on to configure the next unit.
Enter address: 192.168.10.100.
You will be asked login and password. When making
the settings for the first time insert the default login
and password.
•
Login:
admin
• Password: 1234
The product control interface is displayed if login is
successful.
Fig. 1
The product can work via ONVIF or TCAM
(VIDEOTEC) protocol. In the event the
ONVIF protocol is used, make sure to set the
time correctly in the device or to configure
an NTP server. (1.3.5 Network Configuration
page, page 9).