Lights
To turn the lights on, press the “Lights” button
on the keypad or remote control.
Brightness (For XGA/VGA Only)
The camera starts up with a standard
brightness level. To make it brighter, press the
“Brightness” button on the keypad. Each time
you press the button, the brightness level
increases one increment up to a maximum of
ten (10) levels. After you’ve reached the
highest level, the control cycles down to the
lowest level.
Outputs: VGA, SVGA, XGA
The DocCam Pro Digital Camera provides
direct high-resolution input to your LCD projec-
tor or multi-scan monitor according to the video
graphic standards below. Select the output
mode you desire. If you are uncertain which
mode to use, determine the age of your projec-
tor; generally, the newer the projector, the higher
the resolution.
• VGA requires a resolution of 640x480 pixels
(lowest)
• SVGA requires a resolution of 800x600 pixels
• XGA requires a resolution of 1024x768 pixels
(highest)
NOTE:
It is not necessary to
use the IllumaFlex
lights if the room is
normally lit. The lights
are needed only when
the room is very dim –
when using an LCD
projector, for instance.
7
Figure 6 – DocCam Pro Digital’s keypad.
button on the keypad or remote control to zoom
in or out.
2.)
Release the button when the zoom is at the
desired level. The camera will focus
automatically when the zoom motion stops.
XGA
SVGA
VGA
BRIGHTNESS
ZOOM OUT
ZOOM IN
LIGHTS
POWER
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
