NOTE:
Be sure that you pull
out the arm to its maxi-
mum extension. The
camera is calibrated to
accurately focus only
when the telescoping
arm is completely
extended.
CAUTION
Do not move the
telescoping arm
in or out when it is
in the horizontal
(flat) position.
Setting Up Your DocCam Pro Digital
Integrated Document Camera
1.)
Carefully remove camera and parts from
foam packing material. For ease of shipping
the camera is packed with its telescoping arm
flat.
2.)
Set the unit on a flat, solid surface. Unpack
and identify the other parts:
• Power supply
• Connecting cables for the DocCam Pro Digital
– S-VHS video cable
– Video and stereo audio cable (3-
plug to 3-plug; yellow is video,
red and white are audio cables)
– VGA monitor cable
– USB cable
• Remote control unit
• Two (2) AAA batteries
• USB software disk*
3.)
To move the telescoping arm to its normal
upright position (see cover photo), pull the
spring pin at the base and raise it. The pin will
click into three (3) different positions: flat, 45
degrees and straight up. Then loosen the
knurled compression ring on the arm’s midpoint
and extend the arm until it stops. Tighten the
compression ring.
Figure 1 – Loosening and tightening the
compression ring.
*To install software disk, please refer to the manual included on the CD-ROM.
3
