Victron energy Lynx Smart BMS 500, Руководство пользователя

Страница: 10 / 40

5.2.2. Mounting and interconnecting Lynx modules
This paragraph explains how to attach several Lynx modules to each other and how to mount the Lynx assembly into its final
location. These are the points to take into consideration when interconnecting and mounting Lynx modules:
• If Lynx modules are going to be connected to the right and if the Lynx module is fitted with a plastic barrier on the right side,
remove the black plastic barrier. If the Lynx module is located as the most right module, leave the black plastic barrier in place.
• If Lynx modules are going to be connected to the left, remove the red and black rubber sleeves. If the Lynx module is located as
the most left module, leave the red and black rubber sleeves in place.
• Remember that for a Lynx Smart BMS, the left side is the battery side and the right side is the DC system side.
• Connect all Lynx modules to each other using the M8 holes and bolts on the left and right. Take care that the modules correctly
slot into the rubber joiner recesses.
• Place the washer, spring washer and nut on the bolts in the correct order and tighten the bolts to a torque of 14Nm .
• Mount the Lynx assembly in its final location using the 5mm mounting holes.
Lynx module
M8 bolt
M8 Spring washer
M8 Washer
Lynx module
Connection sequence when connecting two Lynx modules
5.3. Electrical connections
5.3.1. Connect DC wires
For all DC connections the following applies:
• All cables and wires connected to the Lynx module need to have been fitted with M8 cable lugs.
• Pay attention to the correct placement and order of the cable lug, washer, spring washer and nut on each bolt when attaching
the cable to the bolt.
• Tighten the nuts with a torque of 14Nm .
M8 bolt
M8 Spring washer
M8 Washer
Cable lug
Lynx module
Correct placement of the M8 Cable lug, washer, spring washer and nut
Lynx Smart BMS
Page 7 Installation