CUTMASTER 102
PARTS REPLACEMENT
Manual 0-4998
7-6
7.07 Rear Panel Parts Replacement
A. Filter Element Assembly Replacement
The Filter Element Assembly is in the rear panel. For better
system performance, the filter element should be checked
per the Maintenance Schedule (Subsection 5.02), and either
cleaned or replaced.
1. Remove power from the power supply; turn OFF the
gas supply and bleed down the system.
2. Remove the Cover per subsection 7.04-A.
3. Locate the internal air line and the fitting from the filter
assembly. Number 1 in the following illustration.
4. Hold a wrench or similar tool against the locking ring
on the filter assembly fitting, then pull on the hose to
release it. (Numbers 2 and 3 in the following illustra
-
tion).
Art # A-07989
1
2
3
4
5
6mm
5. Remove the fitting from the filter element assembly
by inserting a 6 mm hex wrench into the internal hex
fitting and turning it counter clock-wise (left). Numbers
4 and 5 in the previous illustration.
6. Disconnect the input line from the filter element as
-
sembly.
7. Remove the filter element assembly through the rear
opening.
NOTE
If replacing or cleaning just the filter element refer
to the following illustration for disassembly.
Art # A-07990
Filter Element
8. Install the new or cleaned assembly by reversing these
procedures.
9. Turn ON the air supply and check for leaks before
reinstalling the cover.
B. Voltage Selection Switch Replacement
Tools required: T20 Torx Driver, 9/16” wrench
1. Remove the Cover per subsection 7.04-A.
2. Disconnect J3 from the Logic PCB
3. Remove retaining nut securing the switch to the rear
panel.
4. Feed the wires and connectors out of the panel
5. Install replacement filter by reversing above steps.
C. Input Power Cable Replacement
Tools required: T20 Torx Driver, Phillips Head Screwdriver,
Flathead Screwdriver,
1. Remove the Cover per subsection 7.04-A.
2. Disconnect the input cable wires from the W1 contactor
terminals and ground lug.
3. Loosen the two screws in the cable strain relief
4. Remove cable through the rear panel.
5. Install replacement Input Power Cable by reversing
above steps.
6. Reinstall the power supply cover
Содержание CUTMASTER 102
