7
to desired range
z
Turn on or turn off the back light (when arrive the setting time the back light can automatically off)
z
Power-on or off the power supply (POWER)
These operations are described in remainder of Section 3.
DISPLAY
The meter has a 5-digit, Liquid Crystal Display (Primary Display) and a 4-digit, Liquid Crystal Display
(Secondary Display). The display shows measurement readings, measurement units and messages.
As shown in Figure 3-1.
INPUT TERMINALS
The input terminals, as shown in Figure 3-2, are located
on the right of the front panel
The meter is protected against overloads up to the
limits shown in Table 3-1. Exceeding these limits poses
a hazard to both the meter and operator.
Figure 3-2. Input Terminals
Table 3-1. Input Limits
FUNCTION INPUT
TERMINALS
MAXIMUM
INPUT
V
V
Ω
and COM
1000V dc on all ranges
V
~,
FREQ and dBm
V
Ω
and COM
750V ac rms,1000V peak on all ranges
mA and mA
~
mA and COM
500mA dc or ac rms
A
~
and A
~
10A and COM
10A dc or ac rms
Ω
V
Ω
and COM
250V dc or ac rms on all ranges
V
Ω
and COM
250V dc or ac rms on all ranges
All Functions
Any terminal to earth
1000V dc or ac peak
SELECTING A MEASUREMENT FUNCTION
Press a function button, as shown in Figure 3-3, to select a measurement function. When you select
a function, annunciators turn on to indicate the function selected. Rang and full scale values are
summarized in Table 3-2 for voltage, current, ohms and frequency
Reading Rate
High Voltage
Relative Modifier
Primary Display
Diode Test
Continuity Test Save
Function and Unit
Annunciators
Secondary Display
Time
Hold
MIN MAX
Modifier
Autorange
Calibration state
Figure 3-1. Display Annunciators
MAX
750V
1000V
10A FUSED
250V
ALL INPUTS
1KV MAX
FAST FUSE
500mA
mA
Volts, Ohms, Diode Test input Terminal
Common Terminal. Retern Terminal
for all Measurements
Amperes Input Terminal. For
Current Measurements up to 10A
continuous
Milliamperes Input Terminal.
For Current Measurements
up to 500mA
