2
Section 1
Introduction
INTRODUCING THE DUAL DISPLAY MULTIMETER
In this manual, “WARNING” is reserved for conditions and actions that pose hazard(s) to the user;
“CAUTION” is reserved for conditions and actions that may damage your meter.
NOTE
This manual contains information and warnings that must be followed to ensure safe operation and
retain the meter in safe condition.
WARNING
READ THE “MULTIMETER SAFETY” SHEET BEFORE USING THE METER.
The Dual Display Multimeter is a 5-digit high resolution mode. The meter is designed for bench-top.
The features provided by the meter are:
z
A dual, Liquid Crystal, Display that allows two properties of an input signal to be displayed at the
same time
z
True
rms
AC.
z
30 MHz in frequency measurement
z
10µV sensitivity in volts DC
z
Decibels with variable reference impedance measurement capability.
z
A compare mode to determine if a measurement is within, above, or below a designated range.
z
Slow and Fast selectable count resolution, with reading speeds of 3 and 6 reading per second,
respectively.
z
Built-in self-tests with closed-case calibration (no internal calibration adjustment).
z
Isolation of Universal Serial Bus(USB) Port
z
Remote Control, display, record, Data Analysis, print with computer.
WHERE TO GO FROM HERE
This manual has been organized to assist you in getting started quickly. It is not necessary for you to
read the entire manual before using the meter effectively. However, we recommend that you do so in
order to use your meter to its full advantage.
Begin by scanning the Table of Contents to familiarize yourself with the organization of the manual.
Then, read Section 2, “GETTING STARTED”. Refer to the appropriate section of the manual as
needed. The contents of each section are summarized below.
SECTION 1. INTRODUCTION
Introduces the Dual Display Multimeter, describing its features and users manual.
SECTION 2. GETTING STARTED
Explains how to prepare the meter for operation and get started quickly taking basic measurements
from the front panel.
SECTION 3. OPERATING THE METER FROM THE FRONT PANEL
Provides a complete description of each operation that can be performed using the pushbuttons on
the front panel. Section 3 is organized so that related operations and functions are grouped together.
SECTION 4. MAINTENANCE
Describes how to perform basic maintenance and how to replacing fuses as order
SECTION 5. CALIBRATION
Introduces the required equipment, ambient environment station for calibration and the process of
calibration.
SECTION 6. SPECIFICATIONS
MULTIMETER SAFETY
The Dual Display Multimeter has been designed and tested according to IEC Publication 1010 Safety
Requirements for Electronic Measuring Apparatus. This manual contains information and warnings
