Victaulic VG412, Инструкция по эксплуатации и техническому обслуживанию

Страница: 21 / 46

VG412
20
10. Engage one-half of the gear plate over the track rollers on the lower half of the frame and roll to
engagement with the pinion (pinion gear on the lower half of the frame should be in middle of gear
plate half). Hold the first half of the gear plate in this position while engaging the other half of the
gear plate over the track rollers and bring the two halves together. Engage and secure the swing bolts.
11. Select the spacer block that corresponds with size pipe to be cut and grooved.
12. Retract cutoff blade for at least 1/2" nominal clearance when attached to the gear plate.
13. Attach the cutoff blade assembly on top of the spacer block, with the screws provided, to the face of
the gear plate securely.
Figure 21
14. Rotate gear plate manually completely around the pipe to find the “high spot”. Press the detent lever
and turn crank counter clockwise until there is approximately 1/32" to 1/16" clearance between pipe
and edge of cutoff blade at the “high spot”
15. Rotate the gear plate until the blade assembly is at the bottom near the actuator bar.
Figure 22