Victaulic VG412, Инструкция по эксплуатации и техническому обслуживанию

Страница: 10 / 46

VG412
9
TOOL SET-UP
This section has four parts: (1) general set up instructions: (2) set up instructions for short pipes (less than
12 inches): (3) set up instructions for long pipes: and (4) set up instructions for tool installed around the
pipe, for example, in the field with a pipe already in position.
GENERAL
The VG 412 is intended for shop or field use. It will cut and groove 4" through 12" (100 - 300mm) pipe
from full lengths down to approximately 12" in length. Pipe must be adequately supported as the unit is
not intended to carry the weight at the pipe. (Support both ends of pipe if necessary. ) Short lengths of
less than 36" can be accomplished with the use of the pipe stand. The tool and pipe supports must be
placed on level ground. See Operator Instructions, Tool Set Up #2, Dangerous Environments.
GENERAL PROCEDURES
Remove all components from the container, and be sure that all necessary items are included. See list
under Receiving Tool.