Victaulic VG412, Инструкция по эксплуатации и техническому обслуживанию

Страница: 17 / 46

VG412
16
16. The actuator bar should be set to engage the star wheel with approximately 1/32" clearance at the
bottom of the star wheel. Fine adjustment can be made with the two wing screws found in the slots of
the actuator mechanism base.
Figure 14
17. Prepare to support the piece of pipe that is being cut off.
18. Plug in the power drive and activate tool by depressing foot switch. After two or three revolutions the
cutoff blade will contact pipe intermittently, and after a few more revolutions will be cutting
completely around the O.D. of the pipe. Because the cut started intermittently, it will end
intermittently, meaning it will be through the pipe wall at some places before others
19. After pipe is completley cut off, remove foot from switch and allow tool to stop rotating
20. Unplug power cord to power drive until further needed.
21. Loosen wing screws and retract actuator bar (can be tapped with a soft mallet)
To cutoff another pipe return to step number 7.