Victaulic VE26 Series, Инструкция по эксплуатации и техническому обслуживанию

Страница: 12 / 44

4. Install the power drive mounting plate onto
the tool by placing the hole in the mounting
plate over the drive nut . The two screws in
the tool must align with the two holes in the
mounting plate, as shown above .
5a. Insert a hex head cap screw into a hole in
the mounting plate and tool body . Install a lock
washer onto the end of the hex head cap screw,
and thread a hex nut onto the end of the hex
head cap screw . Repeat this procedure with the
other hole in the mounting plate and tool body .
5b. Tighten the two hex nuts to secure the
mounting plate to the tool body .
POWER DRIVE SETUP
WARNING
• DO NOT plug the power drive into
the electrical source until instructed
otherwise.
• Accidental startup of the tool could result
in serious personal injury.
The VE26 tool is intended for field or shop setup
and can be attached to a Victaulic VPD752
Power Drive or a Ridgid 300 Power Drive with
a 38-rpm maximum chuck speed . The power
drive kit, which includes a special power drive
mounting plate and hardware, must be ordered
from Victaulic .
1. Remove all components from the packaging,
and ensure that all necessary items are
included . Refer to the “Receiving the Tool”
section .
2.
Select a location for the power drive, tool,
and pipe stand by taking into consideration the
following factors (refer to the drawing below for
overall dimensions):
a. The required power supply (refer to the
power drive manufacturer’s instructions)
b.
Adequate space to handle pipe/tubing
lengths
c. A firm and level surface for the power
drive, tool, and pipe stand
d. Adequate clearance around the tool for
adjustment and maintenance
A C
B
D
Dimensions - inches/millimeters
A B C D
45.00
1143.0
37.00
939.8
41.00
1041.4
43.00
1092.2
TM-VE26_12 REV_C
TM-VE26 / Operating and Maintenance Instructions Manual