7.
Loosen the chuck to remove the pipe from
the power drive . If a pipe stand is not being
used, manually support the pipe during removal
to prevent it from falling as it separates from the
tool .
8.
Disconnect the tool from the electrical source
if no additional grooving will be performed .
USING THE GROOVE
CONFIRMATION CABLE
At the beginning of a grooving session, confirm
groove specifications of the first completed
piece with the provided groove confirmation
cable .
Carefully check the groove diameter (“C”
dimension) using the provided groove
confirmation cable . Refer to the “Roll Groove
Specifications” section .
CAUTION
• The “C” dimension (groove diameter)
must conform to Victaulic specifications
to ensure proper joint performance.
Failure to follow this instruction could cause
joint failure, resulting in personal injury and/or
property damage.
After confirming that the groove meets
specifications, the operator may commence
grooving . It is not necessary to re-check groove
specifications unless the operator experiences
difficulty or notices unusual tool behavior .
16
REV_C
TM-RG2910
/ Operating and Maintenance Instructions Manual
Содержание RG2910
Страница 2: ......
