Victaulic RG1200, Инструкция по эксплуатации и техническому обслуживанию

Страница: 16 / 24

3a. Remove the upper roll shaft by drawing it
out from the upper roll assembly .
3b. Remove the upper roll from the tool body .
GOOD
BAD
4. Place the alternate upper roll into the tool
body . Note the orientation of the upper roll . The
longer end of the upper roll, which contains the
size markings, shall face out (away) from the tool
body, as shown above .
5. Replace the upper roll shaft into the upper
roll assembly and re-tighten the set screw until
hand-tight .
LOWER ROLL CHANGING
1.
Verify the appropriate roll size by checking the
marking on the front of the roll .
2.
Using the 8 mm hex key provided, loosen the
set screw on the back of the drive shaft .
16 REV_D
TM-RG1200 / Operating and Maintenance Instructions Manual