22
Firmware Update Procedure
1. Save the firmware file to your computer.
2. Go to Setup > System > Maintenance within the camera web browser setup.
3. In the Firmware Update section, browse to the desired firmware file on your computer.
Then click OK.
NOTE: Do not disconnect power to the unit during the upgrade. The unit will restart
automatically after the upgrade has completed (1~5 minutes).
4. If you suspect the firmware upgrade for the camera has failed, always wait at least 5-10
minutes before restarting the upgrade process.
5. Vicon reserves the right to charge for any camera repair which can be attributed to
faulty upgrading by the user. Always read the upgrade instructions and firmware
release notes before updating the firmware.
System Reboot
There are two ways to reset the camera.
Case 1) Using the web browser:
1. Go to SETUP > System > Maintenance.
2. Click “System Reboot” button and wait 1 minute for camera to reboot.
Case 2) Using the Reset Button of the camera:
1. Press and hold for 5 seconds, then release the button.
Factory Default Reset
There are two ways to reset the camera back to factory defaults.
Case 1) Using the web browser:
1. Go to SETUP > System > Maintenance.
2. Click “Factory Default” button.
Case 2) Using the Reset Button of the camera:
1. Push and hold the Reset button for more than 10 seconds.
2. Release the Reset button.
NOTE: The unit will now have the default IP address from a DHCP server.
Use the 'Multi-Upgrade Tool' to discover and connect to the camera.
