V9360W Hemispheric Camera with Advanced WDR
Hardware User’s Manual
2) Ethernet Port
The IP device connects to the Ethernet via a standard RJ-45 connector. Supporting NWAY, this
IP device can auto detect the speed of local network segment (10Base-T/100Base-TX
Ethernet).
3) Reset Button
Step 1:
Switch off IP device by disconnecting the power cable
Step 2:
Press and continue to hold the Reset Button (with a sharp tipped object, like a pen.)
Step 3: Reconnect the power cable while continuing to hold the reset button.
The red
Power LED light will flash on for 3 second first, turn off for about 15 seconds, flash on for
another second and turn off again. By this time the reset to default operation is already
completed.
This will take around 20 seconds from power up
(this length of time fluctuates
slightly with the environment). You may then release the Reset Button. The Power LED light
will come back on and stay on after a few more seconds. The unit will start up with factory
default settings automatically.
On (3s)
On
1s
Power On
About 20 Seconds
Stay On
Off (about 15s)
Off (10~15s)
Restore to Default
Complete
4) Power Button
Press the Power Button and the camera will reboot automatically.
5) Audio Input/Output
The IP device supports audio input and output via terminal block.
6) Digital Input/Output
Used in applications like motion detection, event triggering, time lapse recording, alarm
notifications, etc., the I/O terminal connector provides the interface to:
- Digital output
(2)
- For connecting external devices such as relays and LEDs. Connected
devices can be activated by Output buttons on the Live View page or through video
management software. Connect Pin 2 with Pin 4 or Pin 6 with Pin 8.
8
