Entrance : Entrance counting mode. The object move in through the entrance,
counting number increases
Size : Press Enter button adjust the size of the Entrance zone.
Posi : Press Enter button adjust the Position of the Entrance zone.
Alarm Cnt : Set alarm out entrance count. Alarm count number is
delaying number before output alarm.
Reset Cnt : Entrance count reset.
2)
Sens Down
: Adjust to Motion Sensitivity using left/right Buttons
Crossing objects are ignored. Multiple objects will not be detected.
If the distance is increases between the camera and entrance, the result may be
inaccurate.
Camera Installed at the ceiling
Several Objects
No crossing objects
The distance is too long
Crossing Objects
One object in detection zone
<Picture/DNR>
1) Sharpness :
Adjust sharpness of outlines
(0~15)
2) Resolution :
Select high resolution mode (Low/Mid/High)
3) 2D-NR :
Select 2D noise reduction level (0~6)
2D-NR : Noise reduction on a frame
4) 3D-NR :
Select 3D noise reduction level (0~31)
3D-NR : Noise reduction through several frames
5) DNR Demo :
Select DNR Demo Display On/Off using the Left and Right Buttons
14
None DNR Effect
Display
DNR Applied
Display
<Effect/Special>
1) d-Effect(Digital Effect) :
Select digital Flip/Rotate state (Off/Rotation/Mirror/V Flip )
2) Nega :
Select negative color state(on/off)
3) d-PTZ
(Digital Pan, Tilt, Zoom)
: Adjust d-PTZ.
Func : Press the Enter button to turn digital zoom on/off.
Zoom : Use the Left and Right buttons adjust to digital zoom(0-255).
Pan&Tilt : Press the Enter button to access the Pan&Tilt.
Use the Left and Right buttons adjust to digital pan
