16
••••
Maintenance
XX017-01-00 Rev 702 V1400X-IDL Intelligent Distribution Line Control
Maintenance
This unit does not require any scheduled maintenance. If a unit does not operate and replacement of the fuse,
as described below, does not correct the problem, contact Vicon’s Service Department.
Fuse Replacement
If the unit is plugged into a known good outlet, and does not display an illuminated Power LED, replace the
Fuse. The Fuse is located in the Power Block at the rear of the unit, as shown in Figure 17.
1. Unplug the Line Cord from the outlet and the Power Block.
2. Remove the Power Block Fuse Cover and remove the Fuse from the Active Slot.
3. Replace the Fuse with one specified for the appropriate model, as stated in the Technical Information
Section of this manual.
4. Replace the Fuse Cover, connect the Line Cord and confirm that the Power LED illuminates.
Figure 17
Rear Panel Power Block
