XX017-01-00 Rev 702 V1400X-IDL Intelligent Distribution Line Control
Installation
••••
9
V1400X-DVC System Console
Connect the 6 dressed wires from the other end of the
Station 1 (J1) cable to the RJ-45 Termination Box
screw terminals. From here, use the RJ-45 to RJ-45 6-
foot cable, provided with the System Console, to
connect between the Termination Box and the System
Console.
1. Fabricate the cable as described above. Connect
the 6 dressed wires to the RJ-45 Termination Box
as shown in Figure 6.
2. Connect the System Console (RJ-45 connector)
end of the 6-foot cable to the RJ-45 connector on
the System Console, as shown in Figure 6.
3. Connect the other end of the 6-foot cable (RJ-45
connector) to the Termination Box.
4. Connect additional cables to consecutive Station
connectors (2, 3, 4, etc.).
NOTE: All unused station (STAT) port Terminal Blocks
are terminated with an end-of-line jumper. Remove this
small wire between the Response In - signal (Pin 5)
and Ground (Pin 4) when using the port.
NOTE: Refer to Vicon Instruction Manual XX090 for
information on daisy chaining additional System
Console units to the V1400X-DVC Master System
Console.
Figure 6
STAT 1 (J1) - STAT 10 (J10) Pin Definition for
V1400X-DVC Cable
