X992 Rev 202 V1305R-DC
Technical Information
••
25
Technical Information
ELECTRICAL
Input Voltage:
V1305R-DC1, V1305R-DC2: 120 VAC, 60 Hz.
V1305R-DC1-230, V1305R-DC2-230: 230 VAC, 50 Hz.
Power Consumption:
50 W. (Associated equipment, such as pan-and-tilt and auxiliary devices,
are not included in power ratings.)
Heat Equivalent:
2.8 btu/min. (0.7 kg-cal/min).
NOTE: These figures represent the conversion of 100% of the electrical energy
to heat. Actual percentage of heat generated will be less and will vary from
product to product. These figures are provided as an aid in determining the
extent of cooling required for an installation.
Fuse:
120 VAC: 1 A slo blo (delay).
230 VAC: 0.5 A slo blo (delay).
Fuses must be HRC (ceramic).
Video Input/Output:
BNC connectors, 1 V p-p composite video (EIA and CCIR).
Receiver Control Input:
V1305R-DC1, V1305R-DC1-230 (NOVA): RS-422 communications. Terminal
block on main PCB accessible through cable entry fitting on receiver
enclosure for communication to and from CPU and next receiver in line. Two
leads differential RS-422 command. Two leads differential RS-422 response.
Two leads shield ground. Up to five miles distance between receivers when
using Belden No. 9182 shielded twisted-pair wires or equivalent. Baud rate
selectable from DIP switch on main PCB.
V1305R-DC2, V1305R-DC2-230 (Vicoax II): TTL communications. Two BNC
connectors route control signals from the Vicoax transmitter to receiver and
connect the video from the camera to the receiver.
Auxiliary Functions:
Terminal block on main PCB accessible through cable entry fittings on the
receiver enclosure. Settings are normally open (NO). Selectable momentary
or latching. Two relays installed; two additional driver outputs (optional
relay board available).
Pan-and-Tilt Output:
24 VDC. Terminal block on main PCB accessible through cable entry fittings
on receiver enclosure.
Lens Drive Output:
9.5 VDC.
Terminal block on main PCB accessible through cable entry fittings.
Autoiris:
Receiver-based autoiris control. Autoiris level potentiometer on main PCB.
Radio Frequency
Emission Rating:
FCC Class A.
European Community (CE)
Standard:
Emissions: EN 55022: 1994 +A1: 1995 +A2: 1997.
Harmonic Emissions: EN61000-3-2: 1995+A1: 1998+A2: 1998.
Flicker: EN6100-3-3: 1995.
Immunity: EN 50130-4: 1995+A1:1998.
