Vicon Surveyor MKII, Руководство по программированию для пользователя

Страница: 8 / 30

5
To call up an auto tour
1. Enter one of the following code combinations to call up the
designated auto tour:
Press "8+6+PRESET" to call up Auto Tour 1;
Press "8+7+PRESET" to call up Auto Tour 2;
Press "8+8+PRESET" to call up Auto Tour 3;
Press "8+9+PRESET" to call up Auto Tour 4.
3.5 Setting and Calling up Autopan
With the AUTOPAN features, the domes can automatically move
back and forth between two pre-defined positions (AUTOPAN
boundaries). This allows the domes to continuously scan through
an area when no manual operation is performed.
The parameters of autopan, such as direction, speed, dwell time,
title, can be set via AUTOPAN SET menu. The start/end point and
calling of autopan are programmed via Vicon system keypad.
To program and call up an autopan, follow the steps below.
To define the start point Autopan
1. Use the joystick to move the camera to the position that is
desired as the start point.
2. Press PROG button and hold, press the number key 2, and then
release PROG, to enter into the Preset Store mode.
PROG 2 PROG
Press & hold Press the number key Release
3. Press PRESET button, press number keys 9 and 8, and then
press PRESET button to start programming autopan.
PRESET 9
Press Press the number key
1 PRESET
Press the number key Press
4. The following overlay messages will be displayed. Press AUX2
to set the left autopan limit.
To define the end point Autopan
1. Move the joystick to the position to be set as the end point.
2. Press AUX3 to set the right autopan limit.
3. Set the keypad to Normal operating mode.
Note: Vicon control protocol only allows one autopan to be
programmed.
How to call up AUTOPAN
1. Set the keypad to Normal operating mode.
PROG 1 PROG
Press & hold Press the number key Release
2. Press the Autopan key (A/P) to start or stop the autopan.
Moving the joystick will also cancel the autopan operation.
3.6 Special Operations
Other presets to control the dome are provided. The following
table outlines the operations of special functions with Vicon
keypad.
Preset
Number Store/Recall Dome Preset Functions
Using Vicon Control System
1 to 79 Store/Recall Preset Position
80 to 85 Store/Recall Normal Tours
86 to 89 Store/Recall Auto Tours
90 Store Pan/Tilt Locked
94 Store Enter Dome OSD Menu
95 Store Redetect Control Protocol
96 Store Program Partition Sectors
97 Store Soft Reset
98 Store Set Auto Pan Limits
99 Store Set Manual Pan Limits
8
PROG 1 PROG
Press & hold Press the number key Release