21
Function:
Sets the type of Relay output.
Option:
Momentary/Latched
STATE DISPLAY
Function:
Sets if the Relay state should be displayed.
Option:
ON/OFF
ROW/COLUMN
Function:
Sets the position of the Relay state text if enabled.
Option:
0 – 11/0 - 24
Chapter V Operations under Different
Protocols
5.1 PERFORMANCES AND FEATURES
Prior to operations, make sure that DIP switch, baud rate and
address have been set correctly according to related protocol.
The following table shows the performances and features of the
domes under protocols.
PELCO-P/ PELCO-D/VICON
Baud Rate
2400/4800/9600/19200BPS
Camera Addresses
255
Preset (controlled by
keypad)
254
Auto Tour
4
Autopan
4
Sectors
16
Home Return
Yes
Motion Control
Associated to presets 1 - 79
Alarm Input
4 inputs, associated with presets, autopan,
auto tour
Relay Output
1 output
5.2 OPERATIONS
For detailed operations under different protocols (including
CAMERA CALL-UP, PAN/TILT, TELE /WIDE, OPEN/CLOSE,
FAR/NEAR), refer to users’ manuals of the control system being
used.
Menu programming of the
domes is basically the same for all
protocols as that shown above. Follow the instructions shown on
the screen during operation.
For Preset, Autopan, Auto Tour setup and calling up, shortcut
operations for special functions, refer to the table that follows.
This shows the operation code via
Pelco keypad/control system
the Pelco protocols.
Keypad operation code commands for PELCO-D/P protocol:
Commands
Status
Function
1~32, 35~64
PROGRAM
Set preset 1~32, 35~64
OPERATE
Call preset 1~32, 35~64
74~90
PROGRAM
Set preset 74~90
OPERATE
Call preset 74~90
100~254
PROGRAM
Set preset 100~254
OPERATE
Call preset 100~254
69
PROGRAM
Save pattern
70
PROGRAM
Set pattern 1
OPERATE
Call pattern 1 (cycle)
71
PROGRAM
Set pattern 2
OPERATE
Call pattern 2 (cycle)
72
PROGRAM
Set pattern 3
OPERATE
Call pattern 3 (cycle)
73
PROGRAM
Set pattern 4
OPERATE
Call pattern 4 (cycle)
91
PROGRAM
Set/save autopan 1
OPERATE
Call autopan 1 (cycle)
92
PROGRAM
Set/save autopan 2
OPERATE
Call autopan 2 (cycle)
93
PROGRAM
Set/save autopan 3
OPERATE
Call autopan 3 (cycle)
94
PROGRAM
Set/save autopan 4
OPERATE
Call autopan 4 (cycle)
95
PROGRAM
Enter menu
32+SHOT
PROGRAM
Restore alarm action
manually
OPERATE
33
OPERATE
Call auto flip
34
OPERATE
Manual home return
97+1/2/3/4/5/
6
OPERATE
Call tour 1 ~ 6
98
PROGRAM
Set motion detection
OPERATE
Call motion detection
99
OPERATE
Call autoscan
