Outdoor Dome Series | Quick Guide
10
2.2.3 Installing the Desiccant
1.
Lift to open the inner liner.
2.
Secure the desiccant (via the sticker that is attached to the desiccant) on the inside part of inner liner as
shown in the following figure.
Figure 2 - 2: Installing the Desiccant
3.
Return the inner liner back to its default position after desiccant installation.
2.2.4 Connecting the Cables
The I/O interfaces are on the front of the camera module. Make the appropriate cable connections.
1.
Based on your needs, connect the power cable to the power port via one of the following 3 options.
24 VAC:
Connect a power cable that supplies 24 VAC power source to the power terminal.
12 VDC:
Connect a power cable that supplies 12 VDC power source to the power terminal.
NOTE:
Be sure the polarities match when using 12 VDC power source.
PoE (Class 3):
Connect an Ethernet cable terminated with a
short-bodied
RJ-45 connector to the
PoE RJ-45 port for both power supply and network connectivity purposes simultaneously.
2.
Connect BNC cable for video output, if required. BNC cable is used to connect to the video input terminal
of a monitor, switcher, etc. (to be terminated with 75 ohm impedance). Do NOT pass the BNC cable
through the supplied rubber grommet, as that will damage the waterproof protection. Refer to step 8 below
for how to properly use the supplied grommet.
Desiccant
