6 | © 2020 Viavi Solutions (3 Feb 2020) — viavidoc.com/observerstart
Caution:
The drive does not properly initialize if the JBOD unit(s) are not started first. If
this happens, restart the head unit.
The power button is located on the front of the appliance. This process may take a couple
of minutes.
14.
Turn on the head unit (A1) and wait for the RAID to initialize.
After plugging in the power cords, wait until the blue Information LED starts to blink. Press
the power button once. The power button is located on the front of the appliance. The
control board initiates the power up sequence in three seconds. The entire process may take
a couple of minutes.
15.
In Windows, change the
for the
ETH0
port (shown as
ETH0
in
Network Connections
in Windows) using information supplied to you by your network
administrator.
The default IP address (
192.168.1.10
) is printed on a sticker attached to the top of the
appliance.
16.
Ensure the time zone settings match your environment.
17.
in the BIOS using a static IP address provided
by your network administrator.
18.
in the BIOS using a static IP address
provided by your network administrator.
19.
Double-click the Observer icon on the Desktop to start Observer.
Your hardware appliance is installed and on your network.
Next, give the
ETH0
IP address and IPMI port address, if using, to the Observer administrator.
They need the addresses to add this GigaStor probe to Observer to capture network traffic
with a probe instance.
