www.desatech.com
118531-01C
22
FIREPLACE
INSTALLATION
Continued
Figure 33 - Connecting Wall Switch to
Control Valve
To Wall Switch
Accessory
INSTALLING OpTIONAL WALL
MOUNT SWITCH - GWMS2
1. Connect one terminal of 25 ft. wire for
wall switch to TPTH terminal on valve.
Connect remaining wire terminal to TH
terminal on valve. Make sure that wire ter
-
minals are in positions on unit as pictured
in Figure 33. If wires are not connected as
shown switch will not work.
2. Route 25 ft. wire through openings pro
-
vided on the sides of burner system to a
convenient location to mount your switch.
3. Connect one bare wire end to each of
terminal of GWMS2 wall switch.
4. Install wall switch and cover in the wall.
IMPORTANT
: Do not use any other wire than
that provided with the GWMS2 wall switch kit.
Do not exceed 15 ft. of distance from the valve
connection. Using wire of higher gauge or turns
or exceeding the minimum distance will increase
resistance at the control valve causing unreli-
able performance of fireplace controls.
Figure 34 - Attaching Alkaline Battery to
Receiver
9-Volt
Alkaline
Battery
Receiver
Terminal
Wires
Battery Clip
Figure 35 - Mounting Remote Receiver to
Bracket
Installing 9-Volt Alkaline Battery in Hand-
Held Remote Control Unit
1. Remove battery cover on back of remote
control unit.
2. Attach terminal wires to a 9-volt alkaline
battery (not included). Place battery into
battery housing.
3. Replace battery cover onto remote control
unit.
Figure 36 - Installing Battery in Hand-
Held Remote Control Unit
9-Volt
Battery
Battery
Housing
Battery Cover
Terminal
Wires
Remote Control Unit
Towards Front
REMOTE ON OFF
Remote Receiver
Plastic Mounting Clips
INSTALLING OpTIONAL WIRELESS
HAND-HELD REMOTE CONTROL
FOR MILLIVOLT IGNITION - HRC100
AND HRC200 SERIES
NOTICE: Use only alkaline bat-
teries (not included).
Installing Remote Receiver
1. Open bottom louver and locate switch
bracket on the right.
2. Locate battery clip mounted on back of
the receiver. Slide a 9-volt alkaline battery
(not included) through clip.
3. Attach terminal wires to battery (see
Figure 34).
4. Connect wires from receiver to TH and
TPTH to control valve (see Figure 33).
5. Locate the two plastic mounting clips
provided with kit.
6. Use the clips to mount receiver on
remote mounting bracket as shown in
Figure 35.
