13
/
14
OK/SPN
: Confirmation starts, ready to print becomes the progress display percentage, the file selection page is
returned after the engraving is completed.
6.5 Settings page:
X+
/
X-
: Chang Baud rate;
Y+
/
Y-
: Change Feed rate by 100/Click;
Z+
/
Z-
: Change Feed rate by 10/Click;
6.6 WiFi Network
The offline controller has WiFi wireless network function. By default, the WiFi hotspot of VIGO-STK**** is automatically
established. You can connect to the hotspot through the WiFi of your computer or mobile phone, and then open
192.168.0.1
or vigostick.local in browser to manage (upload or delete) the files on the SD card of the offline controller,
and you can also enter the SSID (Only support 2.4G signal) account and password to help the offline controller access
your local WiFi network. After the controller is connected to the local 2.4G WiFi, the current IP address of the controller
or the domain name vigostick.local can still be opened to enter the web management interface. You can open
About
page of the controller to check the IP address.
Network status
:
There is a dot in the upper left corner of the main page.
The
RED
dot indicates that VIGO-STK****
hotspot is active, and the
GREEN
dot indicates that the controller has connected to Local WiFi.
The web management interface is as follows:
7. FAQ
Q: How to use the lasers
A: 1. For XTS05/XTS08/XTS10/XTS15 laser, please place the material flat under the laser, and make the distance between
them within 3~10cm (Less distance will not be able to focus). Turn on the weak light, then there will be a light spot on
the material, just turn around the focus ring on laser to adjust the spot become smallest and clearest, which means the
best focus.
2. XTS15D laser is fixed focus laser which is not adjustable. The fixed focal Length is 18mm. Please use the focusing
column to determine the distance from the engraved object to the
top surface of copper ring of light outlet.
Q: Laser module can't burn anything, no light, weak power.
A: 1. Please check power, speed setting on software and adjust focus length for laser [refer to
3.2
above to adjust focus].
Q: The picture engraved is the opposite of the original picture
A: Just need to adjust on software [ Reversal X/Y axis]
Q: The picture engraved distortion.
A: The screw rod and motor shaft are not locked and slipping.
S3018 Pro Ver 2.3
